This process is only for air compressor with oil screw
For the oil screw, figure out two processes: gas flow and oil flow, basically you can master the working process of air compressor, and do a better job of operation and maintenance.

Typical oil flow
1. The oil and gas barrel acts as a fuel tank, and most of the oil is in three positions, namely, the bottom of the oil and gas barrel, the compressor and the oil cooler.
2. After starting up, the oil and gas barrel quickly establishes the pressure (the role of the minimum pressure valve), and pushes the oil to start the cycle. This is also the reason why the oil screw air compressor is not configured with oil pump.

3. After flowing out from the bottom of the oil and gas barrel, the lubricating oil is divided into two ways, one way into the oil cooler, and the other way into the entrance of the temperature control valve.
The core of the temperature control valve is the temperature sensor, usually called the temperature package.
The temperature package induces the change of oil temperature and produces the volume change, which drives the displacement of the spool, and then adjusts the mixing of hot and cold oil. Ensure that the lubricating oil works at optimum temperature.
The temperature package of the general air compressor can drive the volume change of the spool displacement. The temperature is about 60-70 degrees Celsius, and the action begins at 60 degrees Celsius. When it reaches 70 degrees Celsius, the outlet of the oil cooler is completely opened, and the cold oil of the cooler and the hot oil without the cooler are mixed at the temperature control valve and enter the host.

4. Before entering the compressor, the lubricating oil will pass through the oil filter to remove metal particles and impurities in the oil, so that the oil entering the compressor is clean to protect the safe operation of the compressor.

5. Finally, after the lubricating oil is mixed with the air in the compressor, it enters the oil and gas barrel together. Due to the high-speed selection of the mixed flow, most of the oil directly falls back into the oil and gas barrel, and a small part will fall down after the oil separation core.
At this point, the lubricating oil has completed a cycle




