As the name implies, an air compressor is a device that compresses gas. Nowadays, most large enterprises are using air compressor air filter. Air compressor air filter is to make clean and clean gas enter the air compressor, so the air filter of the air compressor is very important, and the air compressor filter In the middle of the pre-filter and post-filter, the role is definitely not the same. Then the following Zhejiang filter manufacturers give you a detailed description of the difference between the pre-filter and the post-filter of the air compressor?
The same is the filter, so what is the difference between the pre-filter and the post-filter?
Pre-filter: removes part of the liquid water, lubricating oil and particles larger than 1μm in diameter. Whether it is an adsorption dryer or a refrigerated dryer, it is necessary to configure a pre-filter. Otherwise, the rust and other particulate matter on the pipe will be greatly reduced, and even the evaporator will be damaged.
Post filter: removes the oil mist concentration in compressed air to a higher standard while removing particulate matter greater than 0.01 μm and oil content greater than 0.001 ppm. Under normal circumstances, almost no liquid water is discharged from the rear filter. If there is, the gas water separator or the drain valve inside the dryer is faulty.
Air compressor air filter
The pre-filter can perform preliminary filtration and purification treatment on the compressed air, which can filter out a large amount of water, oil and large particles, and at the same time play a protective role. The post filter is relatively precise. If the compressed air containing a large amount of impurities is not protected by the pre-filter, it can be directly treated by the post-filter, which may cause blockage or even damage.
In general, although the difference between the pre-filter and the post-filter is very large, it is complementary, and the pre-filter and the post-filter are indispensable in the air compressor filter.




