What Are The Maintenance Methods Of The Air Filter

Oct 20, 2019 Leave a message

1, remove the filter element

Release or untie the access cover. Since the filter element is tightly attached to the outlet tube to create a sealing effect, there will be some initial resistance, similar to the seal on the separate jar. Gently move the end cap part of the filter back and forth to seal separately, then turn it while the wallpaper pulls out. Do not knock on the filter housing. If your air filter has a safety filter, replace it the third time you replace it. Replace the safety filter as you would replace the main filter. Always cover the air filter outlet tube to prevent any unfiltered contaminants from being transferred into the engine.

2, clean the inside and outside of the outlet tube two surfaces, while checking the rubber dust valve.

Wipe the sealed surface of the filter element and the inside of the outlet tube with a clean cloth. Contaminants on the sealed surface can prevent an effective seal and cause leakage. Make sure that all contaminants have been removed before inserting a new filter element. Any dust and foreign objects accidentally transferred to the outlet tube can be inhaled into the engine causing wear and tear. Engine manufacturing believes that even a few grams of contaminants can destroy an engine, be careful not to damage the sealed area on the tank. If your air filter is equipped with a dust valve. Visually inspect and squeeze by hand to ensure that the dust valve is greedy and free of damage or congestion.

3, check the old filter for signs of leakage

Visually check the old filter elementfor any signs of leakage. Measured in the filter element, if striped dust forms. Then there is a leakage phenomenon of the table people. Eliminate any causeof leaks before installing a new filter element.

4, check the new filter element for damage.

Carefully examine the new filter element and pay attention to the internal test at the end of the opening, which is a sealed area. The damaged filter element is not installed. The new sealing filter may have some lubricant on the sealing surface to help install.

5, correctly insert the new radial seal filter

After installing the safety inner core in place, carefully insert the filter. Make sure that the filter element is fully in the air filter before tightening the lid. The main sealing ring area has the ability to adjust and distribute the sealing pressure evenly. In order to achieve a tight seal, apply pressure by hand on the outer edge of the filter element instead of the soft center part (do not push the center of the polyurethane section) If the end cover is found to be colliding with the filter element when installing the end cap, the filter element is not installed in place, push the filter element further into the air filter by hand and try the end cap again to cover without extra force


Send Inquiry

whatsapp

Phone

E-mail

Inquiry