Precautions for using air compressors in hot and humid weather

May 14, 2025 Leave a message

It's the season when the rotor of the screw machine head rusts in a year. To prevent your screw machine from being shut down and suffering losses due to rust caused by water accumulation, the following usage precautions should be taken

1,Appropriately extend the unloading time of the air compressor and artificially raise the oil temperature to above 80℃ for operation.

2,Before and after installing the air compressor, it is necessary to fully understand the user's gas consumption situation. It is very important to check the actual operating rate of the client!

3,When the gas consumption is low, after the screw machine has been shut down for 6 hours, regularly drain the condensate water in the oil and gas tank until you see the engine oil flowing out. The frequency of discharge depends on the operating environment of the screw machine.

4,For users with particularly low gas consumption, adjust the heat dissipation appropriately

5,Drain the water in the oil and gas tank once a week. The method of draining: Before starting the machine in the morning, open the oil drain valve of the oil and gas tank until a small amount of lubricating oil flows out, and then close the valve.

36b86f04e1326a5ddf859194c008702

Send Inquiry

whatsapp

Phone

E-mail

Inquiry