A new round of cooling is coming, which is a challenge for both human beings and screw air compressor equipment. Under low temperature environment, the unit is prone to oil breakdown, insufficient oil supply, nose stuck or difficult to start up and other faults, so when the operating environment temperature of the unit is lower than 0 degrees Celsius, it can not be directly started and needs to be preheated in advance. Before starting, refuel from the air inlet, manually turn several laps, pre-heat the oil to divide the tank and start it three times. Click method: press the start button, run for about 6-8 seconds, then press the emergency stop button to stop, repeat the above steps after 30 seconds.
Matters needing attention:
1. When moving, if you want to stop the machine, you need to press the emergency stop button to stop the machine. You can't press the stop button to stop the machine.
2. When heating the oil tank, be sure to block the oil mirror to prevent baking.
3. When the screw air compressor equipment is shut down, open the air storage tank, dryer, pipe and other drainage valves. Be sure to drain the condensate water clean and then close the valve, so as not to damage the electronic components due to low temperature.
4, if it is unable to manually turn the coaxial asynchronous machine and permanent magnet machine, but also according to the steps of several times after the start of the machine, to avoid damage caused by lack of oil host.
Low operating temperature of screw air compressor unit will affect the circulation of cooling water, lower than 0℃, it is easy to freeze the machine, so we should pay attention to the low operating temperature of the unit. Secondly, oil should also be changed and adjusted according to the season to choose low freezing point lubricating oil in winter to ensure smooth oil circulation.




