When you are preparing to buy an air compressor, you should first determine the working pressure required by the air end, add a margin of 1-2 bar, and then select the pressure of the air compressor. (The margin is the pressure loss from the installation site of the air compressor to the actual air end pipeline distance, and properly consider the pressure margin between 1-2 bar according to the length of the distance.) Of course, the size of the pipeline diameter and the number of turning points are also factors that affect the pressure loss. The larger the pipeline diameter and the fewer turning points, the smaller the pressure loss. Otherwise, the pressure loss is greater.
Therefore, when the distance between the air compressor and the gas end pipeline is too far, the diameter of the main road should be appropriately enlarged. If the environmental conditions meet the installation requirements of the air compressor and the working conditions permit, it can be installed at the nearest gas end.
Selection of volume flow:
1. When choosing the volume flow of air compressor, we should first understand the volume flow of all gas equipment, and multiply the total volume of flow by 1.2 (that is, amplify 20% allowance);
2. For the new project, Marco selects the type according to the flow value provided by the design institute;
3. Know the volumetric flow parameters of gas equipment from gas equipment suppliers and select the type;
4. The transformation of air compressor station can refer to the original parameter values and the actual gas consumption for selection;
The proper selection is beneficial to the user and the air compressor equipment. Too much waste in selection and too small selection may cause the air compressor to be in the loading state for a long time or not enough gas or pressure to play up.
The relationship between power and working pressure and volume flow
Under the condition of constant power, when the speed changes, the volume flow rate and working pressure also change accordingly; For example: a 22KW air compressor, the working pressure is determined to be 7bar during manufacturing, the speed is calculated according to the technical curve of the compressor host, and the exhaust is 3.8m3 /min; When the working pressure is determined to be 8bar, the speed must be reduced (otherwise the drive will be overloaded), at this time, the exhaust volume is 3.6m3 /min; Because, with less speed, less exhaust, and so on.
Power selection is to meet the working pressure and volume flow conditions, the power supply capacity can meet the matched driving motor power.
Therefore, the steps of selecting air compressor are: first determine the working pressure, then determine the corresponding volume flow, and finally, the power supply capacity.




